Allen-Bradley 2711-CBL-PM05 Communication Cables

The Allen-Bradley 2711-CBL-PM05, also cataloged as the 2711-CBL-PM05 OIT Cable, operates as a dedicated hardware component for serial data communication and application programming between PanelView operator interfaces and host controller platforms. Spanning a physical length of 5.0 m (16.4 ft), it establishes direct point-to-point RS-232 connection between 9-pin D-shell (DB9) serial ports and 8-pin Mini-DIN system channels.

Hardware Specifications

Profinet / EtherNet/IP Deterministic Networks & Firmware Flash Compatibility

The cable assembly provides point-to-point physical layer connection for real-time register updates and runtime application downloads. Maintaining full firmware flash compatibility across PanelBuilder32 programming environments and connected PanelView operator terminals, the double-shielded conductor layout suppresses high-frequency electromagnetic interference (EMI). Heavy-duty outer jacket shielding prevents cross-talk and ground loop degradation across the complete 5.0 m cable run.

Frequently Asked Questions

Q: What are the connector configurations on the 2711-CBL-PM05 cable?

A: The cable features a 9-pin D-shell (DB9) connector on one end and an 8-pin Mini-DIN connector on the opposite end for direct serial connection.

Q: What is the total length of the 2711-CBL-PM05 interconnect cable?

A: The physical cable length is 5.0 m (16.4 ft).

Q: Does the 2711-CBL-PM05 require external power or an active interface module?

A: No, the 2711-CBL-PM05 is a passive copper interconnect cable that routes RS-232 serial signals directly between compatible ports.

Field Installation Guidelines

1. Power off the target PanelView operator terminal and host controller before connecting or removing serial interface cables.
2. Align the 8-pin Mini-DIN connector keyway with the terminal serial port and push firmly into place.
3. Attach the 9-pin D-shell connector to the host controller or PC serial port, hand-tightening both retaining screws.
4. Route the cable through grounded panel wire ducts, keeping it separated from AC line power leads and VFD motor cables.
5. Ensure any cable shield grounding connection is secured to the enclosure protective earth (PE) bus bar.