ALLEN-BRADLEY 2711P-RBB10 PanelView Plus Bezel

The Allen-Bradley 2711P-RBB10, also cataloged as the 2711P-RBB10 Replacement Bezel, operates as a dedicated hardware component for structural housing and environmental enclosure sealing within PanelView Plus 1000 operator interface platforms.

Hardware Specifications

EtherNet/IP Networks and I/O Density Scaling

The replacement bezel provides physical mounting alignment across human-machine interface assemblies that interface with high-speed EtherNet/IP deterministic networks. Engineered to support optimal I/O density scaling on the front control panel, the clear aperture frame maintains sealing integrity without restricting display viewing angles or membrane keypad responsiveness. Integrated alignment guides isolate internal logic structures and firmware flash compatibility components from environmental contaminants and industrial washdown conditions.

Frequently Asked Questions

Q: What environmental enclosure ratings are achieved once the 2711P-RBB10 bezel is fully installed?

A: When correctly mounted onto a standard panel cutout with an intact gasket, the assembly achieves NEMA 4X, NEMA 12, NEMA 13, and IP66 ingress protection ratings.

Q: Is this replacement bezel compatible with both touch and keypad PanelView Plus 1000 models?

A: Yes, the bezel is engineered to accommodate 10.4-inch PanelView Plus 1000 terminals utilizing either keypad-only or combined keypad/touch input configurations.

Field Installation Guidelines

Ensure all system power is completely disconnected from the PanelView terminal before initiating bezel replacement. Carefully align the industrial-grade plastic housing with the panel cutout, verifying that the perimeter environmental seal rests flush against the cabinet surface. Tighten all mounting levers or screws progressively in a cross-pattern to establish uniform compression, preserving the IP66 ingress protection boundary.