Allen-Bradley 2711P-RBT7 PanelView Plus 700 Touch Bezel

Configured for tactile user input and front-housing enclosure sealing in PanelView Plus and PanelView Plus CE 700 Touch Screen Terminal platforms, the Allen-Bradley 2711P-RBT7 (2711P-RBT7 Replacement Bezel) provides direct physical/electrical execution. This accessory assembly interfaces with the 6.5-inch/7-inch touch panel glass layer to translate finger touch pressure into resistance change coordinate vectors. The unit establishes a protective barrier over internal display electronics to prevent dust and fluid ingress across industrial panel cutouts.

Hardware Specifications

EtherNet/IP Deterministic Networks and I/O Density Scaling

The 2711P-RBT7 touchscreen bezel assembly interfaces directly with the terminal display driver board, preserving system communication response without degrading internal serial transfer timing across EtherNet/IP deterministic networks. High-density trace mapping within the integrated touch overlay maintains coordinate registration precision during continuous operator interactions. Digital calibration factors are processed locally by the host terminal OS, ensuring full firmware flash compatibility and immediate hardware detection upon cold system boot cycles.

Frequently Asked Questions

Q: Does the 2711P-RBT7 bezel require direct wiring to external power supply terminals?

A: No, operational power and signal pathways are supplied through internal ribbon cable connections linked to the PanelView Plus 700 base display chassis.

Q: How is the ingress protection seal maintained when replacing the 2711P-RBT7 bezel?

A: Environmental sealing is established by positioning the perimeter sealing gasket uniformly against the panel frame cutout and torquing rear retaining clips to uniform spec values.

Field Installation Guidelines

1. Disconnect all incoming primary power connections to the PanelView terminal prior to performing bezel maintenance.
2. Wear an grounded ESD wrist strap connected to cabinet earth ground to prevent static damage to internal display board traces.
3. Align the bezel flex ribbon cable with the logic board terminal connector socket and close the locking tab.
4. Seat the bezel into the terminal front housing, ensuring the perimeter gasket sits flush without twist or gap deformation.
5. Tighten all panel mounting clamps in an alternating cross pattern to achieve even sealing pressure against the enclosure wall.