Allen-Bradley 2711P-RDT15C Touch Display Module

The Allen-Bradley 2711P-RDT15C, also cataloged as the 2711P-RDT15C Display Module, operates as a dedicated hardware component for visual operator interfacing and touch signal acquisition within PanelView Plus 6 1500 systems.

Hardware Specifications

EtherNet/IP Deterministic Networks and Firmware Compatibility

The 2711P-RDT15C display module connects directly to a PanelView Plus 6 logic unit to process high-resolution graphical rendering and resistive touch coordinates. High-speed internal backplane interfaces maintain low screen refresh latencies and precise input synchronization with host controllers communicating over EtherNet/IP deterministic networks. Embedded display drivers maintain full firmware flash compatibility across PanelView Plus 6 hardware revisions, enabling rapid panel assembly and field retrofits without requiring logic module re-flashing.

Frequently Asked Questions

Q: Can the 2711P-RDT15C display module be detached or replaced independently of the logic module?

A: Yes. The 2711P-RDT15C is a standalone display assembly that mates directly to a PanelView Plus 6 1500 logic module via captive mounting screws, allowing field replacement without replacing the processing logic.

Q: What precautions should be taken when cleaning the analog resistive touch surface?

A: Clean the touch glass using a soft cloth dampened with mild, non-abrasive industrial glass cleaner. Avoid acidic solvents, abrasive pads, or sharp tools that can damage the outer resistive film.

Q: How is power provided to the backlighting and display electronics?

A: Operating power is delivered directly through the multi-pin backplane interface connector when secured to the PanelView Plus 6 logic module assembly.

Field Installation Guidelines

1. Bezel Inspection and Alignment: Verify that the perimeter sealing gasket is properly seated in the display bezel channel prior to panel installation to maintain enclosure environmental ratings.
2. Logic Module Mating: Align the guide pins on the 2711P-RDT15C display module with the target slots on the logic module. Press the assemblies together firmly and tighten the captive retention screws to torque specifications.
3. Panel Mounting: Insert the combined terminal unit into the enclosure cutout. Secure all panel mounting levers or clamps around the bezel perimeter, applying uniform torque to prevent frame distortion.
4. Grounding and Conduits: Connect the functional earth grounding conductor from the chassis logic base lug to the panel ground bus bar to protect display drive circuitry from electromagnetic interference.