GE IC200ALG240-DB VersaMax Analog Input Module

Configured for high-accuracy signal acquisition in industrial control networks, the GE IC200ALG240-DB (IC200ALG240 Analog Input Module) provides direct physical/electrical execution of voltage and current loop measurements.

Hardware Specifications

Backplane Bus Communication Velocity and Firmware Flash Compatibility

The module executes high-velocity backplane bus communication cycles across the VersaMax I/O rack, transferring 16-bit digitized input values directly to the controller CPU. Integrated flash firmware compatibility guarantees reliable operating logic updates without field configuration loss. Operating over deterministic Ethernet and serial control architectures, the module delivers consistent channel scanning and crosstalk suppression via dedicated channel-to-channel isolation circuits.

Frequently Asked Questions

Q: What power sources are required to operate the IC200ALG240-DB analog module?

A: The module requires two power sources: 150 mA drawn directly from the +5 VDC backplane supply for logic circuits, and an external 24 VDC field power supply to energize the analog input loops and transmitters.

Q: Is field wiring performed directly on the module or through a terminal carrier?

A: Field wiring terminates onto a removable terminal block attached to the VersaMax I/O carrier slot, allowing hot-swap module removal without disturbing field wiring.

Field Installation Guidelines

• Insert the module firmly into any available VersaMax I/O carrier slot until the retention latches engage.
• Connect an external 24 VDC power supply to the dedicated field power terminals on the terminal strip.
• Use shielded twisted-pair cabling for all analog current and voltage inputs, grounding the cable shield drain wire at the module end only to prevent ground loops.
• Separate analog signal wiring from high-voltage AC conductors and motor drive output lines in panel wireways to eliminate electromagnetic noise coupling.