GE IC600BF842 Series Six Analog Input Module

Configured for analog voltage signal processing in Series Six PLC architectures, the GE IC600BF842 (IC600BF842 Analog Input Module) provides direct physical/electrical execution.

Hardware Specifications

Backplane Bus Communication Velocity and Firmware Compatibility

• The module conditions and digitizes 8 bipolar analog voltage channels (-10 VDC to +10 VDC) for high-speed transmission across the Series Six backplane bus. Internal analog-to-digital conversion circuits update channel data matrices synchronously with primary CPU scan cycles.
• Integrated microcode firmware maintains structural flash compatibility across Series Six CPU racks. Operational parameter arrays configure channel sampling sequences without creating bus communication latencies or execution bottlenecks.

Frequently Asked Questions

Q: What input signal voltage range does this module accept across its 8 channels?

A: The module accepts differential bipolar voltage inputs within a -10 VDC to +10 VDC range across all 8 dedicated channels.

Q: Can this module be hot-swapped while the Series Six rack is powered?

A: No, hot-swapping is not supported. Main rack power must be completely turned off and isolated before removing or installing the module to avoid backplane pin damage.

Field Installation Guidelines

• Verify that the main PLC rack power supply is completely shut off and locked out prior to inserting the module into its rack slot.
• Wear a grounded ESD wrist strap attached to an unpainted metal surface of the chassis frame when handling the circuit card.
• Connect field signal wiring using shielded twisted-pair cables, ensuring signal shields are landed at a single chassis earth point to suppress common-mode noise.
• Maintain physical separation of at least 300 mm between low-voltage analog signal wiring and high-voltage AC power lines inside cabinet ducts.