GE IC610CBL100A CPU Programmer Cable

The GE IC610CBL100A serves as the primary IC610CBL100A CPU Programmer Cable utilized to execute programming, diagnostics, and communication tasks across Series One PLC platforms. The cable establishes a physical serial link between programming devices and programmable logic controllers, ensuring stable data transfer for configuration and troubleshooting.

Hardware Specifications

Backplane Bus Communication Velocity and Deterministic Networks

The cable incorporates high-quality insulation and shielded multi-conductor wiring to maintain signal integrity across industrial automation environments. Low capacitance characteristics and continuous shielding prevent electromagnetic interference and signal attenuation, ensuring stable communication velocity between programming units and connected controller nodes.

Frequently Asked Questions

Q: What connector types are utilized at each end of the IC610CBL100A cable?

A: The cable features a 9-pin D-sub connector on one end and a DB25 connector on the other to interface between programmers and GE controllers.

Q: What is the physical length and operating temperature range of the assembly?

A: The cable measures 3 meters in length and operates within a temperature range of -10 deg C to 60 deg C.

Field Installation Guidelines

• Routing & Segregation: Route the programming cable through clean pathways, avoiding high-voltage power conduits and motor leads to prevent electromagnetic interference.
• Connector Engagement: Inspect the 9-pin D-sub and DB25 connector pins for alignment and cleanliness before gently mating them to system ports and securing retention screws.
• Storage & Handling: Avoid sharp bends or excessive mechanical tension on the 3-meter cable span to preserve internal conductor integrity and shielding performance.