GE IC695ETM001-EH Interface Module

The GE Fanuc IC695ETM001-EH serves as the primary IC695ETM001 Ethernet Interface Module utilized to execute high-speed TCP/IP networking across PACSystems RX3i platforms.

Suffix Breakdown & Model Matrix

Hardware Specifications

Backplane Bus Communication Velocity & Firmware Flash Compatibility

The IC695ETM001-EH interfaces directly with the RX3i backplane bus, driving deterministic Ethernet traffic via an embedded 200 MHz processor. Backplane bus communication velocity and network stack response times are optimized for seamless handling of Modbus TCP, EGD, and SRTP protocol messaging. Firmware flash compatibility and field-upgradable logic ensure system-wide synchronicity across local and remote controller nodes without inducing backplane latency.

Frequently Asked Questions

Q: Is the IC695ETM001-EH module hot-swappable while the PACSystems RX3i controller is in RUN mode?

A: Yes. Insertion and removal under power (hot-swapping) are fully supported provided that firmware revision 2.51 or later is active on the host RX3i system.

Q: What function does the integrated RS-232 serial port serve on the IC695ETM001-EH?

A: The RS-232 port provides local connection access to the built-in Station Manager tool at data rates from 1200 bps to 115200 bps for system diagnostics, polling, and security administration.

Field Installation Guidelines

Verify backplane slot alignment prior to inserting the IC695ETM001-EH into any empty Universal Backplane slot (IC695CHS007, CHS012, or CHS016). Tighten the module retaining screws to secure mechanical grounding through the chassis ground rail. Network interconnections must use category-rated 8-pin shielded RJ45 cables. Ensure the metallic shield of all field Ethernet cables is terminated to earth ground according to industrial noise immunity standards to prevent high-frequency electro-magnetic interference.