Honeywell 07170/1/1 FSC EPROM Programmer

Configured for firmware module programming and non-volatile memory chips in Fail Safe Controller (FSC) platforms, the Honeywell 07170/1/1 ( 07170/1/1 EPROM Programmer) provides direct physical/electrical execution.

Hardware Specifications

Process Control & Safety Integration

The Honeywell 07170/1/1 EPROM programmer provides deterministic bit-level memory verification during non-volatile memory programming routines for safety-instrumented systems. Incorporating channel-to-channel isolation across programming signal pathways, the device protects delicate EPROM integrated circuits from voltage transients and ground potential differences during chip programming and readback validation cycles.

Frequently Asked Questions

Q: What primary hardware platform utilizes the 07170/1/1 EPROM programmer? A: The programmer is designed specifically for flashing EPROM modules used within Honeywell Fail Safe Controller (FSC) system safety architectures.

Q: How is power supplied to the 07170/1/1 unit during programming operations? A: Operational and programming voltages are drawn directly from the host system interface terminal connection.

Q: What precautions should be observed when handling EPROM chips with the 07170/1/1 interface? A: Strict anti-static measures must be enforced, as static discharges can damage both the EPROM module memory cells and the programmer pin driver circuits.

Field Installation Guidelines

1. Electrostatic Discharge (ESD) Protection : Connect an anti-static wrist strap to panel earth ground before handling the 07170/1/1 programmer or insertion of EPROM chips.
2. Interface Connection : Ensure host programming terminal power is off before connecting the 07170/1/1 hardware interface to the host system port.
3. Pin Alignment : Carefully align EPROM IC pins with the socket zero-insertion-force (ZIF) lever mechanism to avoid bending leads during connection.
4. Cable Shielding : Ensure shielded communication programming cables are used and grounded at one end to suppress industrial high-frequency noise.
5. Storage Precautions : Store the programmer and unprogrammed EPROMs in anti-static conductive bags when not in active use in the field.