1756-OB16IEF ALLEN BRADLEY CONTROLLOGIX OUTPUT MODULE

Introduction of 1756-OB16IEF

The Allen-Bradley 1756-OB16IEF is a ControlLogix DC digitally-isolated, fast peer-control output module. The 1756-OB16IEF module is electronically fused and protected on a per-point basis, and has 16 individually isolated outputs. The 1756-OB16IEF module responds to commands for system transition in less than 25?S. It also has status indicators to show diagnostic and I/O statuses. A removable terminal block housing, or RTB, is needed before installing the module to the chassis. The only compatible RTBs are the 1756-TBS6H and the 1756-TBCH.

This 1756-OB16IEF module has a fault-reporting feature and it has an additional feature that allows the definition of the time duration before the module transitions from on to off after an error happens. The 1756-OB16IEF module is a CIP Sync slave-only device and it uses the CIP Sync for timestamps and scheduling. As such, another module is needed to act as the master clock of the network. Other features of the 1756-OB16IEF module include configurable point-level output states, output data echo, isolated and non-isolated varieties of output modules, multiple output point densities, electronic fusing, and a diagnostic information latch.

The pilot rating of the 1756-OB16IEF module is 4 A inrush. It has a voltage category of 12/24V DC sink/source, an operating voltage range of 10-30V DC, a current draw of 3 mA at 24V and 320 mA at 5.1V, and a total backplane power of 1.7 W. Its Pulse Width Modulation (PWM) cycle-time is 1 ms min/1 hour max, the PWM on-time is 200 ?s min/1 hour max, and the PWM on-time accuracy is +/-20 ?s. The 1756-OB16IEF module’s minimum load current is 1 mA per point, while its surge current is 4 A for 10 ms per point, repeatable every 2 s. It also has a continuous isolation voltage of 250V. The 1756-OB16IEF module has a maximum off-state leakage current per point of < 0.1 mA per point and a maximum on-state voltage drop of 0.2V DC at 1 A and 0.4V DC at 2 A. Its maximum current per point is 2 A at 45 Degrees Celsius (maximum of 4 channels) but at 60 Degrees Celsius, it is 1 A. The maximum current per module is 16 A at 60 Degrees Celsius, with a maximum of 1 A per channel, and at 45 Degrees Celsius, it is 8 A with a maximum of 2 A per channel.

More About 1756-OB16IEF Information

1756-ob16ief

1756-ob16ief manual

1756-ob16ief user manual

1756-ob16ief wiring

allen bradley 1756-ob16ief

1756-ob16i eds

1756 ob32

1756-ob32

1756-ib32/b

1756 ab

1756-pa

1756-ob

1756-en4t

1756-oa8d

1756-ob16is

1756-of6ci

1756-ib16if

1756-oa16i

ob16e

ob16i

ib16i

ob16ief

1769if4

1756-if6cis

1756-obv8s