Allen-Bradley 2711P-RBT15 PanelView Plus 1500 Accessories

The Allen-Bradley 2711P-RBT15, also cataloged as the 2711P-RBT15 Replacement Bezel, serves as the primary 2711P-RBT Operator Interface component utilized to execute direct touch-input surface protection and mechanical front-panel sealing across PanelView Plus 1500 platforms. Installed directly on the display module assembly, the component houses the analog resistive touch membrane and front perimeter gasket to maintain chassis environmental ratings without replacing the underlying display logic or internal backlight hardware.

Hardware Specifications

Firmware Flash Compatibility & Mechanical Frame Alignment

Designed as a modular front-panel assembly for PanelView Plus 1500 terminals, the 2711P-RBT15 integrates an analog resistive touch screen layer that interface-mates directly to the internal display module ribbon connector. Its mechanical design maintains flush alignment with 15-inch active matrix display assemblies, preventing physical frame distortion during thermal cycling. The sealed front perimeter gasket preserves NEMA Type 12/13/4X environmental ratings, protecting internal backplane logic and communication modules against ambient oil mist, dust, and washdown fluids in industrial control enclosures.

Frequently Asked Questions

Q: Does the 2711P-RBT15 replacement bezel include the internal display LCD logic or backlight?

A: No. The 2711P-RBT15 is a front bezel replacement assembly equipped with the touch screen membrane and perimeter sealing gasket; it does not include the active matrix LCD glass or backlight inverter.

Q: Is system power shutdown required before replacing the 2711P-RBT15 touch bezel?

A: Yes. Power to the PanelView Plus 1500 terminal must be completely isolated before disconnecting the touch screen flexible printed circuit (FPC) tail to avoid static discharge or controller hardware faults.

Field Installation Guidelines

1. Disconnect all primary power cables and network communication lines from the rear of the PanelView Plus 1500 terminal.
2. Remove the complete display module assembly from the control enclosure door and place it face-down on a clean, anti-static work surface.
3. Loosen the perimeter retaining screws securing the damaged front bezel to the rear display housing.
4. Carefully unlatch the touchscreen ribbon cable connector from the display logic board and separate the old bezel from the LCD module.
5. Align the new 2711P-RBT15 touchscreen ribbon cable, insert it firmly into the logic board connector, press the housing together, and tighten all retaining screws to secure the NEMA sealing gasket uniformly.