Bently Nevada TK3-2E Calibration Instrument

Tk3-2E Operation instruction

Scope of Application

Suitable for Bentley-Nevada series 7200 and 3300 probes with diameters of 5mm, 8mm, 11mm,

Verification of 14mm and another non-contact eddy current axial vibration and axial displacement detection probes.

The Purpose

To improve the operation skills of the staff, all staff can correctly use the TK3-2E vibration and displacement probe calibration.

Personnel qualification, number of personnel and division of responsibilities

Qualification and quantity of personnel

Understand the structure and working principle of TK3-2E, and be familiar with the equipment operation specifications and safety precautions

Fixed fault discrimination ability, can deal with the abnormal condition of equipment in time.

Before the operation, the division of labor should be coordinated. Generally, there should be 2-3 persons to carry out the work, 1 person to operate, and other personnel to cooperate with the record number

According to the information, the cooperating personnel should be familiar with tK3-2E precautions, obey the arrangement of equipment operators, and do at the same time

Good care.

Division of Responsibilities

The workshop technical group is the competent department of this work instruction, responsible for the technical guidance and supervision of the work.

Check.

Each shift shall strictly implement the operation technical requirements and the corresponding production safety ban during the operation.

Equipment preparation and requirements

Make sure tK3-2E is intact before the operation and within the limited period of calibration (general calibration micrometer).

Select the appropriate probe clamp according to the size of the calibrated probe.

Select the matching preamplifier according to the probe type.

The digital voltmeter used for measuring voltage must be checked within the valid time of identification. 5 Items must be checked before operation

Check that the probe and component cable assembly is intact, the joint has no oxidation corrosion, and the protective layer at the end should not be used

There are bruising or peeling marks.

Check the integrity of the extension cable, no short circuit, no open circuit, no oxidation corrosion of the joint, and no damage to the protective layer.

Make sure that the probe and extension cable is installed, and connect the power cord after checking correctly, and make sure that the power switch is disconnected

Make sure the output voltage of the power supply and the positive and negative connection of the power line of the preheater are correct before closing the power switch.

Step of shaft displacement probe calibration

Connect the displacement probe to the extension cable as shown in the figure below, and connect the other end of the extension cable to the front-end loader.

Fix the probe on the probe seat with an appropriate probe clamp so that the probe top touches the calibration target.

As shown in the figure above, the front-end power end (-24V DC) and the COMMON end (-24V DC) are connected to the -24V DC power supply. Please pay attention to this

Do not close the power switch.

The common end and output end of the preprocessor are connected to the digital voltmeter. The digital voltmeter used for measurement must be within the validity period of identification

Inside.

After checking everything is correct, close the power switch and send 24V DC to the power end and common end of the preprocessor.

Adjust the screw micrometer on the TK3-2E calibrator to align the indicating number at 0mm, and then set the indicating value of the micrometer

Increase to 0.25mm, record the voltage value of the digital voltmeter, at this point is the output voltage of the preprocessor,(pay attention to the thousandths

The scale of the ruler, if the scale is in inches then a small square is converted to 0.025mm).

Increase the clearance at a value of 0.25mm each time until the indicated value is 2.5mm, and record the output power for each time

Pressure value (checkpoint not less than 10 points)

Our Recommend