GE IC660TBD110 Genius I/O Terminal Assembly

The GE IC660TBD110 serves as the primary IC660TBD110 Terminal Assembly utilized to execute field wiring termination and mechanical interlock across GE Genius I/O network platforms. The base unit acts as the physical wiring housing for incoming field signals and provides structural backplane interconnectivity for Genius electronic blocks (specifically interfacing with the IC660EBD110 electronic assembly for IC660BBD110 series blocks), allowing electronic modules to be unlatched and swapped without disturbing field wiring connections.

Hardware Specifications

Deterministic Network and I/O Density Scaling

The IC660TBD110 terminal base maintains backplane bus communication velocity across internal serial pass-through connector pins to the mated electronic module. Supporting clean I/O density scaling inside control enclosures, the heavy-duty terminal blocks ensure low contact resistance and prevent signal degradation during high-speed sensor sampling. Full firmware flash compatibility is preserved across attached electronic assemblies, maintaining continuous reporting of module diagnostic states to host CPUs without network latency.

Frequently Asked Questions

Q: Can the IC660EBD110 electronic assembly be swapped out without disconnecting physical field wiring?

A: Yes, all field conductors land directly on the IC660TBD110 terminal screws, permitting the attached electronic assembly to be released and replaced independently.

Q: Does the IC660TBD110 require an external power supply to operate?

A: No, the unit is a passive hardware assembly containing internal bus connectors and terminal points with zero active electronic componentry.

Q: What specific Genius components pair with the IC660TBD110 terminal assembly?

A: The IC660TBD110 interfaces directly with the IC660EBD110 electronic assembly to build a complete IC660BBD110 Genius I/O block configuration.

Field Installation Guidelines

1. Mount the IC660TBD110 terminal assembly to the panel backplate using standard mounting screws before landing wiring.
2. Ensure field power circuits and main control supply lines are completely de-energized prior to connecting wiring to the terminal screws.
3. Wire field inputs, outputs, and power lines to the screw terminal block in accordance with the block pinout diagram.
4. Align the IC660EBD110 electronic assembly with the terminal base guides and press firmly until the side latches engage.
5. Bond the terminal assembly ground point directly to the cabinet protective earth (PE) bus to ensure noise immunity across Genius serial lines.