Siemens 6DD1611-0AG0 Simadyn D Coupling Memory Module

6DD1611-0AG0 Simadyn D

The SIMADYN D control system consists of individual components (e. g. subracks, modules, interface modules, operator control panels, position transmitters). The components can be installed in the widest range of system configurations according to individual requirements. When the components are arranged in a distributed fashion (decentral topology) a noisy environment cannot be neglected. Thus, specific requirements are placed on the design and EMC of the system.

Siemens Simadyn D Cabinet

•All SIMADYN D components must be mounted in a metal cabinet

•Each cabinet must have a ground/potential bonding rail, which is connected to the cabinet frame at both ends.

•All SIMADYN D subracks must be connected to the

grounding/potential bonding rail through a 6 mm cable which should be as short as possible. The connection via the PE connection of the power supply is not sufficient.

•Non-damped contactors may not be used in a cabinet with SI MADYN □ components.

•If non-damped contactors are used in a cabinet next to SIMADYN D, then the cabinets must be separated by a metal partition.

•All of the cabinets associated with multi-motor SIMADYN D drives

must be connected through a potential bonding conductor with at least a 16 mm2 cross-section (the customers' PE connection is not sufficient).

•Each cabinet in which SIMADYN D components are installed/mounted must have a screen rail. Serrated rails are suitable. The screen rail must be connected directly to the cabinet frame.

•No gas discharge lamps may be used in the cabinet.

•The screens of incoming cables must be connected directly to the screen rail.

•The cabinets must be designed so that air can circulate freely within them.

Siemens Other Products