TK-IOLI01 Honeywell Direct Control Module

TK-IOLI01 Details

Manufacturer: Honeywell

Product No.: TK-IOLI01

Product Type: Direct Control Systems

IOLIM (IIOLIM (/O Link Module)

Interface for PMIO

For complete information

For consult the PMIO Specification document

Weight: 0.45 Kg

Shipping Weight: 3.5Kg

IOLIM (I/O Link Module), Interface for PMIO.

For complete information, consult the PMIO Specification document.

Hardware Mounting Options

Note that in order to comply with applicable regulations and codes, the controller and I/O racks may have to be located in a room, vault, or enclosure that is accessible only to qualified persons.

Please refer to NEC 110-17, part 1 (1996 National Electrical Code, Copyright 1995 NFPA) or to the appropriate local or national electrical standards for more information.

The rmocouple Input, 6-Point Module

This module has been replaced by TC/TK- IXL062.

When replacing an-IXL061 with the Tx-IXL062 module, it’s necessary to rewire the terminal block.

When the RTP is used, a new pre-wire cable is required.

The Experion Serial Interface Module (SIM), TC-MUX021, enables bi-directional, serial-protocol communications between

the Experion Control Processor and qualified third-party devices.

The SIM uses Field Termination Assembly (FTA) and protocols developed for the APM/HPM product line (see next two pages).

MU-TSIM12, Modbus FTA, supports standard Modbus RTU RS-232 or RS422/485 communications.

MU-TSIA12, Allen-Bradley FTA, supports A-B DF1 serial protocol over Rs232 only.

Note that protocols developed under the PM/APM/HPM Serial Device Interface protocol or the Smart

Transmitter Interface (STI) protocols are not supported.

MU-TSIM12 and MU-TSIA12 use industry standards to support many industrial devices. Contact your Honeywell representative for support of non-standard protocols.

Hot Selling